Ports Tab - microHAM STATION MASTER Manual

Once the virtual ports have been created they must be associated with a specific function or device channel
(e.g., CAT, Rotator, etc.). These assignments should correspond to settings of the application software and
must be configured first in Router then in the application.
IMPORTANT: Correct port assignment is critical for proper operation with application software.
Station Master has six channels – each channel provides an indication of the settings applied by the application
and current state (e.g., or or off):
CAT (uses RxD and TxD)
●
2 nd CAT (virtual "fork" for the main CAT channel)
●
Rotator (uses RxD and TxD )
●
2 nd Rotator (virtual "fork" for main Rotator channel)
●
Auxiliary (uses RxD and TxD)
●
Control (uses RxD and TxD)
●
NOTE: Do not assign virtual ports to the channels/functions that are not used by your applications. It is
unnecessary and only consumes resources.
iLINK couple – used to connect Station Master with a microHAM keyer (microKEYER II, MK2R, or
●
MK2R+).
microHAM © 2016 All rights reserved

PORTS TAB

20