Configuring Microham Usb Device Router; Station Master Status; Initial Setup - microHAM STATION MASTER Manual

The microHAM USB Device Router (Router) program provides a Windows compatible configuration tool for
microHAM USB Devices (Station Master as well as microKEYER II, DIGI KEYER, microKEYER, CW Keyer and
USB Interfaces) and software interface to other Windows applications (logging software, digital mode software,
etc.). The software interface is provided as Virtual Serial Ports.
In order to configure and use Station Master with Windows compatible application programs, you must be
running Router and have turned on Station Master. Router is then configured as required by the application
(logging, control or digital mode) software.
Router must be used to configure Station Master for proper operation. The device configuration tabs (in the red
rectangle) are used to setup each part of the Station Master.
microHAM © 2016 All rights reserved

Configuring microHAM USB Device Router

Station Master
When the USB driver is installed correctly and Station Master is
turned on Router will show a device tab with a GREEN  beside the
device name.
When Router shows a YELLOW "X" instead of a green , it means
the USB driver is correctly installed but Station Master is not turned
on.
When Router shows a RED "X" instead of a green , it means the
device is disconnected and Router does not see the USB part of
Station Master. This happens when the USB cable is unplugged or
the USB driver is not correctly installed.

Initial Setup

Status
13