microHAM STATION MASTER Manual page 50

FUNC button
A short push of the FUNC button will call the FUNCtion
menu. The function number is displayed on the top line in
square brackets followed by the function name. The
function can be enabled or disabled using the left (Yes) and
right (No) buttons. The rotary encoder is used to scroll
through the functions. Changes in status are applied immediately and the values are retained even when Station
Master is turned off.
[f1]Split Ena: Enable/Disable split TX/RX antenna switching. The split enable status is stored separately for
each band.
[f2]Scan Ena: Enable/Disable automatic antenna scanning within a group. Scan is automatically stopped while
the transceiver transmitting.
[f3]Scan Rst: When YES, scan will start always from antenna #1 whenever a scan is initiated or the transceiver
switches to receive from transmit. When NO, scan will resume from the current antenna.
[f4]Sc.PTT Stop: When YES, scanning will not resume after transmitting. When used with microKEYER II or
MK2R, scanning will only be canceled if the transmission was the result of a footswitch (or hand mic)
PTT.
[f5]PA standby: When YES, KeyOut is not generated, and Key in is ignored, regardless of the flags set in
Router
[f6]PA OFF: When YES, POWER SW output on PA connector is kept off regardless of the (per band) PA flag
settings in Router; and KeyIn input is ignored.
NOTE: If Rotator control always active is enabled in Router, two consecutive short presses on the FUNC button
within half a second (a "doubleclick") will toggle this function, rather than enter the FUNC menu.
MENU button
Pushing the MENU button for more than one second will
invoke MENU mode. The menu number is displayed on
the top line followed by the menu name. Item values can
be changed using the Left (Yes) and Right (No) buttons.
The rotary encoder is used to scroll through the items.
Changes in status are applied immediately and persist through power cycles.
[m1]Select band: selects one of the defined bands (band segments) or automatic band decoding (CAT).
[m2]Rota Ena: enables/disables internal rotator controller.
Lights
There are four light on front panel, POWER, ALARM, BUSY and READY.
POWER: Indicates power status of the Station Master.
Off: main power is off
●
On: normal operation
●
Slow blinking: sleep mode .
●
Fast blinking: Input power (+13.8V, Port A or Port B) is out of range (high or low)
●
microHAM © 2016 All rights reserved
50