Ports Tab - microHAM micro2R u2R User Manual

Once the virtual ports have been created they must be associated with a specific function or device channel
(e.g., Control, CW, PTT, etc.). These assignments should correspond to settings of the application
software and must be configured first in Router then in the application.
Proper port configuration is critical for operation with application software.
micro2R has eight channels – each channel provides an indication of the settings applied by the application
and current state (e.g., or or off).
These eight channels (functions) are available for each radio:
FSK (uses TxD for FSK and RTS for PTT if checked)
●
nd
2 FSK (uses TxD for FSK and RTS for PTT if checked)
●
CW (uses DTR or RTS)
●
PTT (uses DTR or RTS)
●
nd
2 PTT (uses DTR or RTS)
●
These channels are common to both radios.
WinKeyer2 (uses RxD and TxD)
●
Control (uses RxD and TxD)
●
Foot Switch (uses CTS, DCD, DSR or RING)
●
NOTE: Do not assign virtual ports for the channels/functions which are not used by your
applications. It is unnecessary and only consumes resources.
microHAM © 2010 All rights reserved

PORTS TAB

20