microHAM STATION MASTER Manual page 11

6. Remove the top cover from Station Master and set the CAT jumpers as shown in the following chart. The
CAT interface jumpers must be configured to select the proper signal level for your transceiver.
RS-232 levels:
All transceivers with RS-232 CAT inputs
IF-232 levels:
Kenwood: TS-140, 440, 450, 680, 690, 711,
790, 811, 850, 940, 950
FIF-232 levels:
Yaesu: FT-100, 736, 747, 757GXII, 767, 817,
840, 857, 890, 897, 900, 980, 990, 1000, 1000D
CI-V levels:
Icom: all radios (except 7700/78xx when
using the DB9/RS-232 jack)
TenTec: all radios with 3.5 mm jack
NOTE: the CAT interface is not configured at the factory.
7. Connect a 13,8 to 16V DC supply to the DC 13.8V jack.
Be sure to observe the proper polarity. Do not turn on Station Master at this time.
8. Locate the USB cable but DO NOT connect it to the USB jack of Station Master at this time.
microHAM © 2016 All rights reserved
11
RS232
IF232
FIF232
CI-V