Siemens Sinumerik 840D sl Diagnostic Manual page 606

Overview of Alarms
HMI-Alarms
Remedy: Approach reference point.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
112350 No swivel data created!
Definitions: There are no swivel data blocks.
Reaction: Alarm display.
Remedy: Set up swivel data blocks (see /FBSP/, ShopMill Description of Functions)
Program Con- Internal
tinuation:
112360 Step was not transferred into program chain%nas program run active.
Definitions: The program that you want to change is being executed in the operating mode "Machine auto". You
can only change programs that are not being executed in the operating mode "Machine auto".
Reaction: Alarm display.
Remedy: Stop the program run in the "Machine auto" operating mode.
Program Con- Internal
tinuation:
112400 Not stored in the Tool Management:%n%1 Program: %2
Definitions: The tool specified in the program does not exist.
Reaction: Alarm display.
Remedy: The tool must be created before the data is saved.
Program Con- Internal
tinuation:
112401 Tool could not be set up:%n%1
Definitions: When reading in the tool data, a tool could not be created.
Reaction: Alarm display.
Remedy: Check tool management.
Program Con- Internal
tinuation:
112402 Work offsets: error on writing
Definitions: Data could not be written to the NC.
Reaction: Alarm display.
Remedy: Should the alarm be displayed again after a new try, please contact the hotline of Siemens AG, A&D
MC.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
112420 Error on changing over inch/metric!%nCheck all data!
Definitions: The switchover of the data for the inch/metric conversion was not completed.
This alarm can only appear in the event of hardware defects.
Reaction: NC Start disable in this channel.
Alarm display.
Remedy: The following data must be checked:
Display MD's:
MD9655: $MM_CMM_CYC_PECKING_DIST
MD9656: $MM_CMM_CYC_DRILL_RELEASE_DIST
MD9658: $MM_CMM_CYC_MIN_COUNT_PO_TO_RAD
MD9664: $MM_CMM_MAX_INP_FEED_P_MIN
MD9665: $MM_CMM_MAX_INP_FEED_P_ROT
MD9666: $MM_CMM_MAX_INP_FEED_P_TOOTH
MD9670: $MM_CMM_START_RAD_CONTOUR_POCKET
MD9752: $MM_CMM_MEASURING_DISTANCE
MD9753: $MM_CMM_MEAS_DIST_MAN
MD9754: $MM_CMM_MEAS_DIST_TOOL_LENGTH
MD9755: $MM_CMM_MEAS_DIST_TOOL_RADIUS
2-606
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG 2009 All Rights Reserved
03/2009