Siemens Sinumerik 840D sl Diagnostic Manual page 1033

03/2009
No. 52
Definitions: Continue block search (PI command)
Should not occur in any alarm
No. 53
Definitions: ! Digitize function removed !
Activate digitization (PI command)
Should not occur in any alarm
No. 54
Definitions: ! Digitize function removed !
Deactivate digitization (PI command)
Should not occur in any alarm
No. 55
Definitions: Enable the function generator (PI command)
Should not occur in any alarm
No. 56
Definitions: 'Disable the function generator (PI command)
Should not occur in any alarm
No. 57
Definitions: Wait for a program marker (channel communication, NC block, WAITM)
Should not occur in any alarm
No. 58
Definitions: Wait for a program end (channel communication, NC block, WAITE)
Should not occur in any alarm
No. 59
Definitions: Program selection from the other channel with synchronization
(Channel communication, NC block INIT + SYNC)
Should not occur in any alarm
No. 60
Definitions: Wait until acknowledgement arrives from MMC (NC block, MMC_CMD)
Should not occur in any alarm
No. 61
Definitions: Activate skip slash blocks
(VDI signal: skip block)
Not permitted if:
1. The nesting depth is too great
Possible actions:
1. Wait until previous ASUB has finished or cancel program
No. 62
Definitions: Deactivate skip slash blocks
(VDI signal: skip block)
Not permitted if:
1. The nesting depth is too great
Possible actions:
1. Wait until previous ASUB has finished or cancel program
No. 63
Definitions: Activate test run.
(VDI signal: rapid traverse override)
Not permitted if:
1. The nesting depth is too great
2. If there is a reorganize brake error
©Siemens AG 2009 All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
List of Action Numbers
3-1033