Siemens Sinumerik 840D sl Diagnostic Manual page 1019

03/2009
410142 TM: Too many toolholders
Definitions: The PLC configuration in the DB4 has more than 32 toolholders
Reaction: Alarm display.
Remedy: Correct tool management start-up
Program Con- Switch control OFF - ON.
tinuation:
410143 TM: Too many revolvers
Definitions: The PLC configuration in the DB4 has more than 32 revolvers
Reaction: Alarm display.
Remedy: Correct tool management start-up
Program Con- Switch control OFF - ON.
tinuation:
410144 TOOLMAN: Multiple definition of magazine number %Z
Definitions: Multiple definition of the magazine number
Reaction: Alarm display.
Remedy: Magazines, spindles, loading points must be uniquely defined in different TO areas
Program Con- Switch control OFF - ON.
tinuation:
410150 Area in M group decoder list is too large
Definitions: Number of M groups in PLC too large.
Reaction: Alarm display.
Remedy: Reduce the number of groups
Program Con- Internal
tinuation:
410151 Magazine data for tool management missing in the PLC
Definitions: Magazine data are not available in the PLC. The start-up has not been completed, although the option
TOOLMAN has been activated.
Reaction: Alarm display.
Remedy: Softkey 'Create PLC Data' must be pressed during TOOLMAN start-up via HMI Advanced. Or create
the data in data block DB4 as from DBB64.
Program Con- Internal
tinuation:
410160 PROFIBUS configuration is too large for DP1
Definitions: Internal data area is too large for PROFIBUS configuration.
Reaction: Alarm display.
Remedy: Define and load a smaller PROFIBUS configuration
Program Con- Internal
tinuation:
410900 M:N: call waiting was not continued
Definitions: The switchover sequence started was not completed
Reaction: Alarm display.
Remedy: Reactuate channel menu on HMI
Program Con- Internal
tinuation:
410901 M:N: HMI 1 does not respond to displacement
Definitions: The HMI that is to be switched over does not respond
Reaction: Alarm display.
Remedy: Reactuate channel menu on HMI
Program Con- Internal
tinuation:
© Siemens AG 2009 All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
PLC alarms
2-1019