Siemens Sinumerik 840D sl Diagnostic Manual page 215

03/2009
If parameter %3= 100 - 104:
Check the setting of MD20112 $MC_START_MODE_MASK and the machine data specified under
'..._RESET_...'. If tool management is active, if necessary remove the tool stated in the associated
alarm from the toolholder/spindle and cancel the 'disabled' status.
If parameter %3= 4 or 5:
Check macro definitions in _N_DEF_DIR
Check cycle directories _N_CST_DIR and _N_CUS_DIR
If parameter %3= 6:
Alarm 18002 or 18003 was also issued. This alarm contains the number of the incorrectly defined pro-
tection zone and an identifier of what is incorrect about the protection zone. The system variables must
be appropriately corrected.
If Parameter %3= 200 bis 203:
Increase MD28070 $MC_MM_NUM_BLOCKS_IN_PREP.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
14711 [Channel %1: ] Transformation selection not possible as axis %2 not
available
Parameters: %1 = Channel number
%2 = Axis name, spindle number
Definitions: Based on the configuration of machine data MD20110 $MC_RESET_MODE_MASK and MD20140
$MC_TRAFO_RESET_VALUE, a transformation shall be selected by performing a reset or control
ramp-up. However, this is not possible as axis %2 required for this is not available. Possible reason:
The axis was occupied by another channel or the PLC.
Reaction: Interface signals are set.
Alarm display.
Remedy: - Use the GET command to get axis %2 in the channel in which the transformation is to be selected.
- Select the transformation by means of the part program command.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
14720 [Channel %1: ] Block %2 axes for centerless transformation not available
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In the channel not all of the axes/spindles are available that have been defined in machine data for
centerless grinding.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department.
1. Modify part program.
2. Modify machine data:
24110 TRAFO_AXES_IN_n
21522 TRACLG_GRINDSPI_NR
21524 TRACLG_CTRLSPI_NR.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-215