Siemens Sinumerik 840D sl Diagnostic Manual page 470

Overview of Alarms
NCK alarms
61162 [Channel %1: ] Block %2: Tool parameter diameter or tip angle incorrect
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggered by the following cycle: CYCLE81
Remedy: - The tool parameter diameter or tip angle must be greater than zero
- Tip angle must be less than 180°
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61175 [Channel %1: ] Block %2: angle of aperture programmed too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The angle of aperture of the text (_DF) in the engraving cycle is too small. This means that the text for
engraving does not fit in the specified angle.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Enter a larger angle of aperture.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61176 [Channel %1: ] Block %2: text length programmed too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The text length (_DF) in the engraving cycle is too short. This means that the text for engraving is
longer than the specified text length.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Enter longer text length
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61177 [Channel %1: ] Block %2: polar text length > 360 degrees
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In the engraving cycle, the polar text length must not exceed 360 degrees.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Enter shorter text length.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61178 [Channel %1: ] Block %2: code page not present
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The specified code page is not supported by the cycle.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Use code page 1252.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
2-470
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009