Timer For Deactivating The Relay; External Ring For Activating The Relay - Siemens HiPath 1100 Programming Manual

Relay and Sensor on the HiPath 1120
Step by Step
...
0 0 0
170
= "Music on Hold": The Relay can be used for acti-
4
5 = "External signal": It is possible to sue the Relay for
Initial state for Programming Mode.

Timer for deactivating the relay

Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1 7 3
2 5 5 Enter the length of time (000 to 255) that the relay must
remain closed. One unit equals 0.5 seconds.
The default is "002" = 1 second.
Press this key.
#
Initial state for Programming Mode.

External Ring for Activating the Relay

This setting lets you use the relay to control a second
ring signal for a specified extension.
Required: Programming Mode must be active (*95
31994).
0 7 1 Enter the code for programming.
Enter an extension number (e.g., 11/101).
Initial state for Programming Mode.
vating external equipment connected for playing
announcements/music.
controlling a second ring for an extension.
When playing music from an external music
source, it is required that all regulations related
to copyrights for the country in question are fol-
lowed.
If the closing time is set to "000," the relay will re-
main active until it is manually deactivated.