S0 Line Operation Mode - Siemens HiPath 1100 Programming Manual

Step by Step
1
, ,
0 1 0 2 0 3
1
S Line Operation Mode
0
This setting specifies the type of connection between
the S
0
nection can be Point-to-Point or Point-to-Multipoint or S
Bus.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
9 0
or Enter the S
1 1
Enter the physical slot for the S
0 0
external line only - PP or PMP)
0 0
0 0
ule, enter Slot 11 and Port 00 ... 04).
... 3 Select the type of connection for the digital line:
= Point-to-Point (PP - default for the first port)
1
2
= Point-to-Multipoint (PMP)
= Bus S
3
Enter the next physical slot for the S
or
Press this key.
#
Initial state for Programming Mode.
[1] Module slots are: HiPath 1120 (02), HiPath 1150 (03) and HiPath
1190 (01 and 11).
Module digital lines and the local carrier. The con-
Module slot on the system
0
... 0 1 = On the HiPath 1120 (Port 00 slot is for
... = For HiPath 1150;
0 4
... = For HiPath 1190 (for the second mod-
0 4
line call (default for all other ports)
0
On the HiPath 1120, the S
for digital line only, PP or PMP . It cannot be pro-
grammed as an S
0
With other systems, the first physical port slot
may also be configured as an S
Programming a Digital Trunk
1
.
module:
0
0 module.
module's first port is
0
bus.
bus.
0
0
139