Call Deflection - Siemens HiPath 1100 Programming Manual

Programming a Digital Trunk
Step by Step
144

Call Deflection

When this feature is available and provided by a carrier,
an incoming call to an extension enabled with Call For-
warding (*11) is routed directly to an external destina-
tion over the public network. Alternatively, the HiPath
1100 system can be used.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
2 2 9
or
* # To activate/deactivate Call Deflection over the public
network.
*
#
fault)
Initial state for Programming Mode.
= Activates using the public network
= Deactivates using the HiPath 1100 system (De-
When there is an incoming call to an extension
activated for external Call Forwarding, the sys-
tem sends information about the call's new des-
tination and the number of the forwarded exten-
sion to the public network. This is done by
means of a Call Deflection activation message.
The call is forwarded over the public network,
which means that on theHiPath 1100, B channels
are not needed.
The local carrier can send to the HiPath 1100 in-
formation about the forwarded call billing.
If external Call Forwarding cannot be carried out
through Call Deflection to the public network, it
will be carried out by the system.