Without Msn Verification; Remote Administration Via Dtmf - Siemens HiPath 1100 Programming Manual

Step by Step
*
*

Without MSN Verification

Remote Administration will be performed without veri-
fying the Service MSN transmitted.
Required: Programming Mode must be active (*95
31994).
0 7 0 Enter the code for programming.
or
Activate/Deactivate:
#
= To activate
*
= To deactivate (default)
#
Initial state for Programming Mode.

Remote Administration via DTMF

With this feature you can configure the HiPath 1100 re-
motely with an MF telephone.
Required: Programming Mode must be active (*95
31994).
1 5 7 Enter the code for programming.
or
Activate/Deactivate remote configuration:
#
*
= Activate remote configuration (default)
*
= Deactivate remote configuration
#
Initial state for Programming Mode.
Replace the handset.
For example, Remote Configuration is enabled and the
programming extension has a conversation in progress
on the external line that will be used for programming.
With a conversation in progress enter the programming
9 9 1
extension code to transfer control of the HiPath 1100 to
the remote programmer.
The remote programmer must now enter the system
password using an MF telephone (default - 31994).
Wait for a confirmation tone to indicate that the pass-
word was accepted.
To set the required configuration, proceed as if the re-
mote telephone was directly connected to the system.
General Programming
115