Ending Remote Administration; Type Of Msn Signal - Siemens HiPath 1100 Programming Manual

General Programming
Step by Step
...
0 0 1
116
With a Fax/DID facility
If the system is equipped with a Fax/DID module pro-
grammed as an external line DID.
9 5 Enter the code using a remote MF telephone after the
*
call is answered.
The remote programmer must now enter the system
password using an MF telephone (default - 31994).
Wait for a confirmation tone to indicate that the pass-
word was accepted.
To set the required configuration, proceed as if the re-
mote telephone was directly connected to the system.

Ending Remote Administration

Required: The remote telephone is in Programming
Mode.
1 9 6 Enter the programming code using the remote MF tele-
phone. This allows the system to free the external line
and the MF code receiver.
Replace the handset.

Type of MSN Signal

This setting lets you choose one of the four types of
rings for various calls, and a ring for registered MSNs.
The default configuration for MSNs is Type 1 ring.
Required: Programming Mode must be active (*95
31994).
0 7 3 Enter the code for programming.
Enter the slot (001... 140) for the MSN.
1 4 0
1 ... 4 Select a type of ring for the selected MSN.
Initial state for Programming Mode.
If the system is connected via serial cable to a
computer that has access to a Telephone Net-
work, the remote programming can be executed
via modem using the HiPath 1100 Manager. See
the Help file for instructions.