Mitsubishi Electric Melsec iQ-R Series User Manual page 122

CH1 Input signal error detection setting
Set a condition for detecting an input signal error.
For details on the input signal error detection function, refer to the following.
Page 40 Input Signal Error Detection Function
Setting value
0
1
2
3
4
If a value other than the above is set, an input signal error detection setting range error (error code: 1C0H) occurs. If Simple
disconnection detection (4) is selected for the channel where the set input range is other than the extended mode, a
disconnection detection enabled range setting range error (error code: 1C6H) occurs.
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Input signal error detection setting
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is Disable (0) for all channels.
APPX
120
Appendix 3 Buffer Memory Areas
Setting details
Disable
Upper and lower limit detection
Lower limit detection
Upper limit detection
Simple disconnection detection
CH1 CH2 CH3
528 728 928
CH4 CH5 CH6
1128 1328 1528
CH7 CH8
1728 1928