Mitsubishi Electric Melsec iQ-R Series User Manual page 110

A/D conversion completed flag
The A/D conversion status can be checked.
b15 b14 b13 b12 b11 b10 b9
0 0 0 0 0
(2)
(1) 0: During A/D conversion or unused, 1: A/D conversion completed
(2) b8 to b15 are fixed to 0.
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
A/D conversion completed flag
■A/D conversion completed flag status
When the first A/D conversion is completed in the channel where the A/D conversion is enabled, the flag turns to A/D
conversion completed (1). 'A/D conversion completed flag' (XE) turns on when the conversion in all the channels where the A/
D conversion is enabled is completed.
■Clearing A/D conversion completed flag
Turning on and off 'Operating condition setting request' (Y9) turns the flag back to the default (During A/D conversion or
unused (0)), and when the first A/D conversion is completed, the flag turns to A/D conversion completed (1) again.
Interrupt factor mask [n]
Set whether to mask interrupt factors.
Setting value
0
1
When 'Interrupt factor mask [n]' (Un\G124 to Un\G139) is changed to Mask clear (Interrupt used) (1) and an interrupt factor
occurs, an interrupt request is sent to the CPU module. When the set value is two or larger, the setting is regarded as Mask
clear (Interrupt used) (1).
"n" indicates an interrupt setting number. (n = 1 to 16)
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Interrupt factor mask [n]
■Default value
The default value is Mask (Interrupt unused) (0) for all areas.
APPX
108
Appendix 3 Buffer Memory Areas
b8 b7 b6 b5 b4
0 0 0 CH8 CH7 CH6 CH5
1 2 3 4
124 125 126 127
b3 b2 b1 b0
CH4 CH3 CH2 CH1
(1)
CH1 CH2 CH3
42
Setting details
Mask (Interrupt unused)
Mask clear (Interrupt used)
5 6 7 8
128 129 130 131
CH4 CH5 CH6
9 10 11 12 13
132 133 134 135 136
CH7 CH8
14 15 16
137 138 139