Connecting To D0-Dcm - Mitsubishi Electric GOT2000 Series Connection Manual

7.5.7

Connecting to D0-DCM

■1. Communication settings
Write the following communication settings to the specified register using the programmer.For details of the register,
refer to the following manual.
➠
KOYO EI PLC user's Manual
Item
Transmission mode
Protocol
Station No.
*1
Transmission speed
Parity
RTS On Delay Time
(Only communication port 2)
RTS Off Delay Time
(Only communication port 2)
Timeout
(Only communication port 2)
485 mode selection
(Only communication port 2)
Data bit
(Only communication port 2)
Stop bit
(Only communication port 2)
The timeout between characters
(Only communication port 2)
The completion of a setting
Reset timeout
*1 Indicates only the transmission speeds that can be set on the GOT side.
Set the same transmission speed of the GOT.
For the transmission speed setting on the GOT side, refer to the following.
➠
7.5.8 Connecting to D2-DCM
■1. Communication settings
Make the following settings using the programmer.
Item
Station No.
*1
Transmission speed
Data bit
Stop bit
Parity
Self-diagnostic mode
Response delay time
Peer to Peer
Master/Slave
Timeout
Transmission mode
MODBUS
*1 Indicates only the transmission speeds that can be set on the GOT side.
Set the same transmission speed of the GOT.
For the transmission speed setting on the GOT side, refer to the following.
➠
HEX
DirectNet
1 to 90
9600bps, 19200bps, 38400bps, 57600bps, 115200bps
NONE, ODD,
EVEN (Only communication port 2)
0ms
0ms
800ms/960ms/1200ms/1600ms/4000ms/8000ms/16000ms/40000ms
RS232, RS422/485 4 line type
8bits, 7bits
1bit, 2bits
0 to 9999ms
Default use,A preset value is effective
Invalid,Effective
7.4.1 Setting communication interface (Communication settings)
1 to 90
9600bps, 19200bps, 38400bps
8bits (fixed)
1bit (fixed)
NONE, ODD
OFF
0ms
OFF
Slave
Enable
HEX
OFF
7.4.1 Setting communication interface (Communication settings)
Set value
Set value
7.5 PLC Side Setting
7
7 - 31