Table of Contents
Advertisement
Praesideo 3.5 | Installation and User Instructions | 9 | System Configuration
43.3.4 Audio outputs
figure 43. 1 3: Configure power amplifier, step 5
Power amplifiers that are configured as spare amplifiers
do not have the Delay (distance) setting. This setting is
table 43.9: Audio outputs configuration
Item
Output
Delay
Amplifier supervision/
Pilot tone
GND Supervision
Line/LSP Supervision
Configure supervision
devices
Bosch Security Systems | 2011-02
Value
0 to 95108 ms (PRS-1P500)
0 to 47554 ms (PRS-2P250)
0 to 23777 ms (PRS-4P125)
0 to 1479 ms (LBB4428/00)
On, Off
On, Off
None
PRS-SVSET (Single)
PRS-SVCO (Multiple)
taken over from the main amplifier that this spare
amplifier replaces when it becomes active. The output
configuration of a spare amplifier is only valid when it is
in spare state.
When the spare amplifier takes over a main amplifier,
the configuration of the main amplifier is copied.
Line/Lsp Supervision can be used to supervise the
interconnection between the spare amplifier and the
connected main amplifiers.
If the connected main amplifiers use Single Line/Lsp
Supervision, then the spare amplifier must not use
Multiple Line/Lsp Supervision, otherwise a conflict will
arise between both supervision slave boards when the
spare amplifiers takes over the from the main amplifier.
If the connected main amplifiers use the Multiple
Line/Lsp Supervision, then the spare amplifier can also
use Multiple Line/Lsp Supervision.
Description
Unique name for the audio output. The output can be
enabled and disabled using the checkbox.
Sets the loudspeaker alignment time, also presented
as distance in meters and feet.
Switches the pilot tone to on (On,) and off (Off). The
pilot tone is used to supervise the amplifier channel for
failures and for supervision of the loudspeaker line and
loudspeakers.
If set to On, the pilot tone enables supervision and an
internal calibration keeps the pilot tone at an optimum
level. If the load on the line changes by the addition or
removal of loudspeakers, the pilot tone stays at the
optimum level.
Switches ground supervision of the loudspeaker line
on (On) and off (Off).
Sets the type of line or loudspeaker supervision.
Opens a screen to configure LBB4441 and LBB4443
supervision devices (see section 43.3.5).
en | 349
Advertisement
Table of Contents
