Table of Contents
Advertisement
Praesideo 3.5 | Installation and User Instructions | 6 | Installation Accessories
25 Crimp the ferrules on the sheath using the crimping
tool (tool 3, see figure 29.25). See figure 29.26 for the
result of this part of the cable-connector mounting
procedure.
figure 29.25: Crimping ferrules (3)
A
figure 29.26: Ferrules on fibers
Bosch Security Systems | 2011-02
29.4.9 Assembling the connector
Before starting to assemble the connector, position the
copper wires and the plastic optical fibers for
installation. The copper wires will be installed in the
upper part of the connector, whereas the fibers will be
installed in the lower part of the connector (see figure
29.27).
figure 29.27: Front view of connector
table 29.3: Optical network connector details
Pin
B
E1
E2
O1
O2
Also, observe the wiring diagram (see figure 29.28). For
the practical implications of this diagram, see
figure 29.29 and figure 29.30).
figure 29.28: Wiring diagram
Note
When replacing a connector, always first check
the wiring in the connector at the other end.
E1
E2
O1
O2
Signal
+48V(DC)
GND
Data
Data
RED
E1
BROWN
E2
O1
O2
BLACK (2x)
en | 288
Wire
Copper
Copper
Optical fiber
Optical fiber
E1
E2
O1
O2
Advertisement
Table of Contents
