Praesideo 3.5 | Installation and User Instructions | 6 | Installation Accessories
11 Slide one of the stripped, copper wires into the
contact area of the socket contact and close the
crimping tool to crimp the socket contact onto the
copper wire (see figure 29.14).
figure 29. 1 4: Crimping a socket contact (2)
12 Repeat steps 10 and 11 for the other stripped, copper
wire. See figure 29.15 for the result of this part of the
cable-connector installation procedure.
A
figure 29. 1 5: Installed socket contacts
Bosch Security Systems | 2011-02
29.4.7 Stripping fibers
Proceed as follows:
13 Slide the plastic optical fibers into the
POF cutter/stripping tool (tool 6). The fiber that is
going to be cut-off must be put in the small guiding
hole, whereas the other fiber must be put in the large
guiding hole (see figure 29.16). The crimping bush
must rest against the stop (see figure 29.17).
figure 29. 1 6: Cutting a fiber (1)
B
figure 29. 1 7: Cutting a fiber (2)
en | 285