Parts To Be Used; Supplied Parts; Separately Sold Parts; Commercially Available Parts - Mitsubishi Electric AE-200A Instruction Book

1. Parts to be used

1-1. Supplied parts

Before using this product, check that the parts listed below are included with your product.
No.
(1) Instruction Book (this manual)
(2) "Charge" license
(3) Initial Setting Tool
(4) Charge Calculation Tool

1-2. Separately sold parts

Use only genuine Mitsubishi Electric products for the components listed below.
Item
PI controller
Surface cover with USB port

1-3. Commercially available parts

Where necessary, prepare the commercially available parts listed below.
Electricity meter
Pulse detector
For PI controller
Communication-
related
*1 When using an external 24 VDC power unit, specify and use a product that meets the UL60950-1 or EN60950-1 safety standard. (Product
with enhanced insulation for the primary/secondary withstand voltage (3 kV, 1 min.)
WT07442X02
Item
Model
PAC-YG60MCA
PAC-YG72CWL-J
Item
DC power unit *1
AC power cable
M-NET transmission
cable
DC power cable
Signal wire
Sleeved ring terminal
PC
Printer
USB memory
LAN cable
Switching HUB
Qty
1
1 for each AE-200/AE-50/EW-50
1
1
Qty
Required number
1 for each AE-200 unit
Qty
Required number
Pulse width: 100-300 ms
Pulse weight: 0.1 kWh/pulse, 1.0 kWh/pulse
Required number If the electricity meter is equipped with a
pulse transmitter that complies with the
pulse width and pulse weight listed above,
pulse detector is not required.
24 VDC±10%, 5 W
Required number
Ripple noise: 200 mVp-p or less
As appropriate For DC power units
As appropriate
As appropriate
As appropriate
Required number
For running Charge Calculation Tool and
1
Initial Setting Tool
1 For printing charge calculation results
For retrieving CSV data (apportioned
1
results)
As appropriate
Required number
7
Remarks
recommended