List Of Tool Bar Operations - Mitsubishi Electric AE-200A Instruction Book

6-4-3. List of tool bar operations

File
Creates, opens (loads) and saves
settings files, and saves settings
files with another name.
[1]
[2]
[3]
[9]
[4] Data acquisition
Acquires settings status of the
centralized controller.
[1] New
Click [File] > [New] in the tool bar to create a new "settings file".
[2] Open
Click [File] > [Open] in the tool bar to load the "settings file" saved on the PC.
[3] Save
Click [File] > [Save] or [Save As...] in the tool bar to save a settings file on the PC.
Note
• After the settings are completed, save the settings file and store it in a safe place.
• The file will not be saved on the AE-200/AE-50/EW-50.
[4] Data acquisition
Loads the AE-200/AE-50/EW-50 settings data on the Initial Setting Tool.
Note
• When changing the AE-200/AE-50/EW-50 settings, make sure to select [Acquire data] first.
Procedures
1. Click [Basic Settings] > [System Configuration] and enter the IP address of the AE-200/AE-50/EW-50 from
which the data is to be acquired. Then click [OK] at the bottom of the screen. (Refer to section 6-5-1 "System
Configuration settings" for details.)
2. Click [Data acquisition] > [Acquire data] in the tool bar.
3. If the settings have been changed, a "Confirmation" screen will be displayed asking you to confirm the save
operation. Select [Yes] to display the "Authentication information input" screen.
Centralized controller system
Centralized controller name
4. Enter the maintenance user ID and password of the centralized controller from which the data is to be
acquired.
If the ID and password are the same as ones for the centralized controller No. 1, check the "Same as No.1"
checkbox.
WT07442X02
[5] Send
Sends the settings data to the centralized
controller.
63
[8] Help
Displays the version of this software.
Option
Able to select the temperature display format
and to output trial run check sheets.
Password input
Enter the password for initial
settings for the centralized
controller.
ID input
Enter the ID for initial settings for
the centralized controller.
Check box
Check the checkbox when the ID
and password are the same as the
ones for the centralized controller
No. 1.
[6]
[7]