Appendix 1. Using The Ae-200 Charge Calculation Support Tool - Mitsubishi Electric AE-200A Instruction Book

Appendix 1. Using the AE-200 Charge Calculation
Support Tool
This section describes how to use "AE-200ChargeCalc.xlsm" (an Excel file), which supports calculation of the air
conditioning charges for each energy management block based on a CSV file of the air conditioning charge ratio
of the electric energy acquisition (no metering device) system output by the AE-200 Charge Calculation Tool.
This tool allows easy calculation of air conditioning charges for each energy management block, data
development in the Bill form, and changing of the Bill form.
Note
• "AE-200ChargeCalc.xlsm" is included in Charge Calculation Tool Ver. 1.10 or later.
When the Charge Calculation Tool is installed, "AE-200ChargeCalc.xlsm" is also installed in the following
folder.
"[Folder in which the Charge Calculation Tool is installed]\Tool"
(Default installation: "C:\Program Files\MITSUBISHI ELECTRIC CORPORATION\AE-200 Charge
Calculation Tool\Tool")
[1] Preparation
Prepare to use "AE-200ChargeCalc.xlsm".
Preparation content
Excel 2013/2010/2007
"AE-200ChargeCalc.xlsm" of AE-200 Charge
Calculation Support Tool
CSV files for air conditioning charge ratio output
from AE-200 Charge Calculation Tool
Outdoor unit electric energy (for the billing period) It is necessary to read the power meter for the billing
Indoor unit electric energy (for the billing period)
Procedures
1. Open the properties for "AE-200ChargeCalc.xlsm" and check that the Read-only check box under Attributes
is deselected.
If the Read-only check box is selected, deselect it and then click [OK].
WT07442X02
Install on the PC to be used and prepare for accessible
status.
Set delimiters ((,) Comma/(;) Semicolon), and decimal
marker ((.) Dot/(,) Comma) for CSV files to be imported.
Prepare files used to calculate the billing period.
period.
125
Remarks