Mitsubishi Electric AE-200A Instruction Book page 22

Note
• In the file name, "IC" denotes energy management blocks, "MC" denotes a PI controller, and "D" denotes
data at 1-day intervals.
• For CSV data (apportioned results), the \(AE-200 serial number)\"ApportionData"\ folder will be created
in the root folder of the USB memory and CSV file will be saved in this folder. Save backup copies of this
folder on the PC.
To check the serial number, touch [
displayed in the bottom-left corner of the login window.
6. Click [Browse] for the CSV file (metering device data), select the "Metering device" data file for the CSV data
(apportioned results) acquired from the AE-200 and then click [Open].
Note
• Refer to
Note
Note
• Register one "Energy management block (tenant)" data file and one "Metering device" data file for each
AE-200 unit.
• For each No., register the "Energy management block (tenant)" file and "Metering device" file output by the
same AE-200.
• If there are two AE-200 units, register the two files in the order in which they are output.
• Do not register multiple CSV files output from the same AE-200. If multiple files are registered, charges
may be calculated higher.
• If there are multiple AE-200 units, the charges will be output in order of registration No.
7. Click [Start calculation].
The charge calculation results will be displayed. (Refer to section 3-4 "Displaying charge calculation
results".)
WT07442X02
in procedure 5 for information on the USB memory save destination and the file names.
Example of CSV file (air-conditioner data) selection
(Output CSV file [App_IC_D_2014-12-21_2015-02-20.csv])
] in the top-right corner of the LCD. The serial number will be
Example of CSV file (metering device data) selection
(Output CSV file [App_IC_D_2014-12-21_2015-02-20.csv])
22