Mitsubishi Electric AE-200A Instruction Book page 64

5. Click [OK] to acquire the data of the settings on the centralized controller. The settings will then be applied
on the Initial Setting Tool.
Note
• If data acquisition fails, the settings on the centralized controller registered in "System Configuration" will
not be applied to the settings on the Initial Setting Tool.
Refer to section 6-5-1 "System Configuration settings".
[5] Send
Click [Send] > [Send settings] in the tool bar to send all Initial Setting Tool settings to the centralized controller.
Note
• This sends the settings data to all the centralized controller IP addresses set in "System Configuration" at
once.
• Always check that all the items that require settings are entered and set before sending the data. Any
items that are not set will be sent to all the centralized controllers as unset items.
• To change the settings, first save the acquired settings and make the setting changes before sending the
settings data.
[6] Temperature unit
Click [Option] > [Temperature] in the tool bar to select the temperature display format on the Initial Setting Tool
from Celsius (°C) and Fahrenheit (°F).
Note
• Switching between Celsius and Fahrenheit consists of changing the unit shown on the Initial Setting
Tool and does not set the unit used on each of the centralized controllers. To change the unit shown on
the centralized controllers, make the settings in "Unit of temperature" setting in [Basic Settings] > [Basic
System].
[7] Output - Check sheet for billing function trial run
Click [Option] > [Output - Check sheet for billing function trial run] in the tool bar to output the check sheet used
for billing function trial runs.
Note
• The check sheet will be output based on the settings on the Initial Setting Tool.
If the settings on the AE-200/AE-50/EW-50 and the Initial Setting Tool are not the same, the billing function
trial will not run correctly. Be sure to complete [5] "Send" before starting the trial run.
Procedures
1. Click [Option] > [Output - Check sheet for billing function trial run] in the tool bar.
Centralized controller
Output type
2. Click the pull-down menu (▼) for "Centralized controller" and select the number for the centralized controller
to be output.
Note
• This centralized controller number is the one set in section 6-5-1 "System Configuration settings".
3. Click the pull-down menu (▼) for "Output type" and select the [Items to be checked during the trial run] for
the first trial run. For the second trial run, select [Items to be checked 10 days after the trial run]. For the third
trial run, select [Items to be checked on the next day of the closing date].
4. Click [Data Output].
5. Set the file name and save destination and then click [Save].
WT07442X02
64
Close
Data Output