Flow Of The Initial Settings On Initial Setting Tool - Mitsubishi Electric AE-200A Instruction Book

6-3-2. Flow of the initial settings on Initial Setting Tool

Follow the procedures from step ③ onwards to make the initial settings for the apportioned electricity billing
function.
As shown in flow ① below, settings data can be created beforehand at another location, such as office, to send it
to the centralized controller on the day of the trial run.
When setting the apportioned electricity billing
① (When making the
initial settings off-site)
By the day
Creating the settings
before the trial
run (at office)
Saving the settings data
On the day of
the trial run
(on-site)
Work on
site can be
reduced
Initial Setting Tool
*1 To change the existing AE-200/AE-50/EW-50 settings, make sure to save the settings file (collected from AE-200) before the change.
*2 After the settings data are loaded on the Initial Setting Tool and the changes are made, do not change the settings on the AE-200's LCD
or from the web browser until you finish sending the setting changes data.
*3 The settings data created on the Initial Setting Tool cannot be loaded or written to the AE-200 using a USB memory.
*4 Store the settings files set on the Initial Setting Tool (pre-change data and post-change data) in a safe place.
WT07442X02
function for the first time
② (When making the
initial settings on-site)
data
On-site system check
Creating the settings
Saving the settings data
Sending the settings data to AE-200
Settings file
(new settings data)
LAN
Sending the settings data via LAN
Collecting the settings data from AE-200
data
Initial Setting Tool
Saving the settings as pre-change data
Saving the settings as post-change data
*3
Initial Setting Tool
60
③ When changing the settings
Settings file
(collected from AE-200)
LAN
Loading the settings data via LAN
Example: 20150401A.dat
Changing the settings
Example: 20150401B.dat
Sending the settings data to AE-200
Settings file
(Post-change data)
LAN
Sending the settings data via LAN
*3
*1
*2
*4
*3