Suzuki Swift Sport 2004 Service & Repair Manual page 763

60) Remove snap ring while the 1st and reverse brake
piston return springs are compressed using special
tool and hydraulic press.
CAUTION
!
Do not press 1st and reverse brake return
spring subassembly in over 0.8 mm (0.031
in.).
Excessive compression may cause damage
to return spring subassembly, discs, plates
and/or piston.
Special tool
(A): 09926–97620
61) Remove 1st and reverse brake retaining plate, discs
and separator plates.
62) Remove 1st and reverse brake return spring
subassembly (1).
63) Turn over transaxle and uncaulk reduction drive gear
nut (1).
64) Secure reduction drive gear (1) with parking lock
pawl, then remove reduction drive gear nut.
CAUTION
!
• It is recommended that this operation
should be carried out on rubber mat to
prevent damaging transaxle case.
• Never reuse removed nut.
65) Using special tools and hydraulic press, remove
planetary ring gear subassembly (1).
CAUTION
I2RH0B510134-01
!
Do not reuse planetary ring gear
subassembly. Otherwise it may cause
damage to planetary gear unit and/or
reduction gears.
Special tool
(A): 09913–84510
(B): 09923–78210
I2RH0B510135-01
66) Remove parking lock pawl shaft, then spring (2) and
parking lock pawl (1).
I2RH0B510136-01
Automatic Transmission/Transaxle: 5A-119
I2RH0B510137-02
I2RH0B510138-01
I2RH0B510139-01