Suzuki Swift Sport 2004 Service & Repair Manual page 436

2B-3 Front Suspension:
Adjustment
1) Loosen right and left tie-rod end lock nuts (1) first.
2) Rotate right and left tie-rods (2) by the same amount
to align toe to specification. In this adjustment, the
lengths "A" of both right and left tie-rod should be
equal.
NOTE
Before rotating tie-rods (2), apply grease
between tie-rods and rack boots so that
boots won't be twisted.
3) After adjustment, tighten lock nuts (1) to specified
torque.
Tightening torque
Tie-rod end lock nut (a): 45 N·m (4.5 kgf-m, 32.5 lb-
ft)
NOTE
Make sure that rack boots are not twisted.
Camber and Caster Check
Check camber and caster by camber caster kingpin
gauge (1) and turning radius gauge (2).
If measured value is out of specified value, check
following items for damage, deformation and crack.
• Strut and component
• Suspension control arm and bush
• Suspension frame
• Wheel hub, steering knuckle or wheel bearing
• Vehicle body
Front camber "a"
: 0 ± 1°
Front caster "b"
: 5°12' ± 2°
NOTE
Front camber and caster are not adjustable.
I3RH0A220002-01
[A]: Camber (Front view)
[B]: Caster (Side view)
F: Forward
Steering Angle Check and Adjustment
When tie-rod or tie-rod end was replaced, check toe and
then also steering angle with turning radius gauge.
If measured value is out of specified value, perform
inspection and adjustment of toe.
Steering angle
Inside: 33.8° ± 3°
Outside: 29.8° (Reference)
[A]
T
S
"a"
"b"
[B]
F
S: Body center
T: Center line of wheel
1
2
I7RS0B220003-01
90°
90°
I7RS0B220004-01