Suzuki Swift Sport 2004 Service & Repair Manual page 989

Condition
Cool air does not come
out or insufficient cooling
(A/C system normal
operation)
Cool air does not come
out only intermittently
Cool air comes out only at
high speed
Possible cause
Insufficient or excessive charge of
refrigerant
Condenser clogged
A/C evaporator clogged or frosted
Evaporator temperature sensor faulty
Expansion valve faulty
Desiccant clogged
Compressor drive belt loosened or
broken
Magnet clutch faulty
Compressor faulty
Air in A/C system
Air leaking from HVAC unit or air duct
Heater and ventilation system faulty
Temperature selector faulty
HVAC control module faulty
Temperature control actuator faulty
Blower motor faulty
Excessive compressor oil in A/C system Drain excessive compressor oil from A/C
Wiring connection faulty
Expansion valve faulty
Excessive moisture in A/C system
Magnet clutch faulty
Excessive amount of refrigerant
Condenser clogged
Insufficient charge of refrigerant
Air in A/C system
Compressor drive belt loosened or
broken
Compressor faulty
Air Conditioning System: Automatic Type 7B-41
Correction / Reference Item
Check the amount of refrigerant and system
for leaks.
Check condenser referring to "Condenser
Assembly On-Vehicle Inspection".
Check A/C evaporator and evaporator
temperature sensor referring to "Evaporator
Inspection" and "Evaporator Thermistor
(Evaporator Temperature Sensor) Inspection".
Check evaporator temperature sensor
referring to "Evaporator Thermistor
(Evaporator Temperature Sensor) Inspection".
Check expansion valve referring to "Expansion
Valve Inspection".
Replace receiver/dryer.
Adjust or replace drive belt.
Check magnet clutch. Referring to "Magnet
Clutch Inspection".
Check compressor.
Replace receiver/dryer, and then perform
evacuation and charge referring to "Operation
Procedure for Refrigerant Charge".
Repair as necessary.
Check HVAC unit.
Check temperature selector referring to
"Inspection of HVAC Control Module and Its
Circuit".
Check HVAC control module referring to
"Inspection of HVAC Control Module and Its
Circuit".
Check temperature control actuator referring to
"Temperature Control Actuator Inspection".
Check blower motor referring to "Blower Motor
Inspection in Section 7A".
system circuit and compressor.
Repair as necessary.
Check expansion valve referring to "Expansion
Valve Inspection".
Replace receiver/dryer, and then perform
evacuation and charge referring to "Operation
Procedure for Refrigerant Charge".
Check magnet clutch. Referring to "Magnet
Clutch Inspection".
Check the amount of refrigerant.
Check condenser referring to "Condenser
Assembly On-Vehicle Inspection".
Check the amount of refrigerant and system
for leaks.
Replace receiver/dryer, and then perform
evacuation and charge referring to "Operation
Procedure for Refrigerant Charge".
Adjust or replace drive belt.
Check compressor.