Suzuki Swift Sport 2004 Service & Repair Manual page 861

3) Pull out input shaft bearing (1) from flywheel (2), use
the following special tool if necessary.
Special tool
(A): 09921–26020
(B): 09930–30104
4) Remove flywheel (1) from crank shaft using special
tool.
Special tool
(A): 09924–17811
Installation
CAUTION
!
Do not reuse flywheel bolts. Otherwise, bolts
may loosen. Be sure to use new bolts with
pre-coated adhesive.
NOTE
Before assembling, make sure that flywheel
surface and pressure plate surface have
been cleaned and dried thoroughly.
1) Install flywheel (2) to crankshaft and tighten new
bolts (1) to specification.
Special tool
(A): 09924–17811
I2RH01530023-01
Tightening torque
Flywheel bolt (a): 70 N·m (7.0 kgf-m, 51.0 lb-ft)
2) Using special tool, install input shaft bearing to
flywheel (1).
I4RS0A530015-02
Special tool
(B): 09925–98210
Clutch: 5C-9
I2RH01530024-01
I4RS0A530016-01