Suzuki Swift Sport 2004 Service & Repair Manual page 599

Circuit Description
EBD warning lamp (brake warning lamp) is controlled by ESP® control module and BCM through lamp driver module
in combination meter.
If EBD system is in good condition, ESP® control module turns EBD warning lamp ON at the ignition switch ON,
keeps it ON for 2 seconds and then turns it OFF.
EBD warning lamp is turned ON continuously at the following conditions.
• EBD system is an abnormality
• Connector of ESP® control module is disconnected
• Parking brake switch is ON
• Brake fluid level is lower than minimum level
The information of parking brake switch and brake fluid level are transmitted from BCM to lamp driver module in
combination meter through CAN communication line.
Troubleshooting
Step
1 Check parking brake and brake fluid level
1) Make sure that:
• Parking brake is completely released.
• Brake fluid level is upper than the minimum level.
Are the check results OK?
2 Check ABS warning lamp
1) Turn ignition switch to ON position.
Does ABS warning lamp come on steady?
3 Check parking brake switch circuit and brake fluid level
switch circuit
1) Release parking brake completely, and replenish brake
fluid.
2) Disconnect BCM connectors with ignition switch turned
OFF.
3) Measure resistance between each terminal of "L01-6",
"E46-5" and vehicle body ground.
∞ Ω
Are resistance
4 CAN communication circuit check
1) CAN communication circuit between combination meter,
ABS (ESP®) control module and BCM referring to "DTC
U1073: Control Module Communication Bus Off".
Is CAN communication circuit in good condition?
Action
?
Electronic Stability Program:
Yes
Go to Step 2.
Perform "ABS Warning
Lamp Does Not Come
ON at Ignition Switch
ON" previously outlined.
Go to Step 4.
Substitute a known-
good combination meter
and recheck. If EBD
warning lamp remains
ON, substitute a known-
good ESP® hydraulic
unit / control module
assembly and recheck.
4F-25
No
Release parking brake
completely and/or
replenish brake fluid.
Go to Step 3.
Check each applicable
circuit for short to
vehicle body ground. If
OK, then check parking
brake switch and/or
brake fluid level switch.
Repair or replace.