1D-65 Engine Mechanical:
Fastening part
Connecting rod bearing cap bolt
Sensor plate bolt
Piston cooling valve
Main bearing cap No.1 bolt (a)
Main bearing cap No.2 bolt (b)
Rear oil seal housing bolt
Flywheel or drive plate bolt
Main bearing cap No.1 bolt
Main bearing cap No.2 bolt
Main bearing cap No.1 bolt
NOTE
The specified tightening torque is also described in the following.
"Air Cleaner Components"
"Throttle Body and Intake Manifold Components"
"Engine Mountings Components"
"Timing Chain Cover Components"
"Timing Chain and Chain Tensioner Components"
"Camshaft, Tappet and Shim Components"
"Valves and Cylinder Head Components"
"Pistons, Piston Rings, Connecting Rods and Cylinders Components"
"Main Bearings, Crankshaft and Cylinder Block Components"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fasteners Information in Section 0A".
Tightening torque
N⋅m
kgf-m
15 N⋅m (1.5 kgf-m, 11.0 lb-ft) and then
retighten by turning through 45° twice
11
1.1
11
1.1
30 N⋅m (3.0 kgf-m, 22.0 lb-ft), 50 N⋅m (5.0
kgf-m, 36.5 lb-ft) and then retighten by
turning through 60°
25
2.5
11
1.1
70
7.0
30 N⋅m (3.0 kgf-m, 22.0 lb-ft), 50 N⋅m (5.0
kgf-m, 36.5 lb-ft) and then retighten by
turning through 60°
25
2.5
30 Nm (3.0 kgf-m, 22.0 lb-ft), 50 Nm (5.0
kgf-m, 36.5 lb-ft) and then retighten by
turning through 60°
Note
lb-ft
/
8.0
8.0
18.0
8.0
51.0
18.0
/