Toro Workman 1100 Service Manual page 96

6. Install input shaft, center shaft, and differential as-
semblies to the case.
1. Shift shaft
A. Insert fork of the shift shaft to the clutch groove of
the center shaft assembly.
3
1. Center shaft assembly
2. Shift shaft
B. Replace oil seals for the input and selector shafts
on the case (LH) if cracked, nicked, or distorted such
that they would not hold a proper seal.
IMPORTANT: Make sure not to damage the oil seal
when installing the input shaft.
Drive Train
2
Figure 69
2
Figure 70
Page 5 – 42
1
2. Clutch groove
1
3. Input shaft
4. Differential assembly
C. Install center shaft assembly with shift shaft and
differential assembly. Then, install input shaft as-
sembly. Lower differential assembly, center shaft as-
sembly, and input shaft assembly into the case at the
same time.
4
Workman 1100/2100/2110