5. Install axle case to case (RH and LH).
1. Axle shaft
2. Snap ring
IMPORTANT: Do not reuse snap ring. Replace snap
ring with new one.
25 to 31 ft–lb
(34 to 42 N–m)
1. Axle case
2. Case
IMPORTANT: Make sure to install the axle case to
the proper side of the case. The right side of the
case takes the short axle case, and the left side
takes the long axle case.
IMPORTANT: Make sure not to damage the oil seal
when installing the axle case to the case.
Workman 1100/2100/2110
Figure 67
3
2
Figure 68
Page 5 – 41
2
3
1
3. Ball bearing
A. Insert axle shaft with snap rings, collar, and ball
bearings into the axle case. Install snap ring to the
axle case.
1
3. Flange bolt
B. Install axle case to the case. Secure each axle
case to the case with flange bolts. Torque bolts from
25 to 31 ft–lb (34 to 42 N–m).
Drive Train