Service And Repairs; Change Engine Oil; Change Engine Oil Filter - Toro Workman 1100 Service Manual

Service and Repairs

Change Engine Oil

Note: Perform this maintenance procedure at the in-
terval specified in the Operator's Manual or Chapter 2
– Product Records and Maintenance.
1. Start vehicle and let it run for a few minutes to warm
the oil.
2. Park machine on a level surface, stop engine, en-
gage parking brake, and remove key from the ignition
switch.
3. Raise bed and support with prop rod (see Operator's
Manual).
4. Disconnect spark plug wires.
5. Remove drain plug and let the oil flow into a drain
pan. When the oil stops, reinstall the drain plug (Fig.7).
Note: Dispose of the used oil at a certified recycling
center.
Note: See Check Engine Oil for the proper type and
viscosity of oil to add to the engine.
6. Pour oil into fill opening until the oil level is up to the
"FULL" mark on the dipstick. Add oil slowly and check
level often during this process. Do not overfill (Fig. 8).
7. Install filler cap and dipstick firmly in place (Fig. 8).
8. Connect spark plug wires.

Change Engine Oil Filter

Note: Perform this maintenance procedure at the in-
terval specified in the Operator's Manual or Chapter 2
– Product Records and Maintenance.
1. Drain oil from the engine (see Change Engine Oil).
2. Remove existing oil filter (Fig.7). Apply light coat of
clean oil to the new filter gasket.
3. Screw filter on until gasket contacts mounting plate,
then tighten filter an additional 1/2 to 3/4 turn further. Do
not overtighten.
Workman 2100/2110
1. Drain plug
1. Dipstick
Note: See Check Engine Oil for the proper type and
viscosity of oil to add to the engine.
4. Pour oil into fill opening until the oil level is up to the
"FULL" mark on the dipstick. Add oil slowly and check
level often during this process. Do not overfill (Fig. 8).
5. Start and run engine to check for leaks.
6. Stop engine and recheck the oil level. Add oil if nec-
essary.
Page 3 – 7 Briggs & Stratton Gasoline Engine
1
2
Figure 7
2. Oil filter
2
1
Figure 8
2. Filler cap