Adjust Shift Cables - Toro Workman 1100 Service Manual

Adjust Shift Cables

1. Park machine on a level surface, stop engine, set
parking brake, and remove key from the ignition switch.
Raise and latch cargo bed.
2. On vehicles with a shift lever neutral position (Fig. 6):
A. Set the shift lever into the Neutral position.
B. The transaxle select lever assembly should be in
a level position.
C. Tighten the locknut on one of the shift cables just
enough to take up any cable slack. Note: the locknut
below the bracket must be held to allow adjustment.
D. Repeat process for other shift cable.
E. Pull up on each shift cable to make sure that there
is no gap between the nut/washer and the select le-
ver. If a gap exists, tighten nut further (Fig. 7).
F. Start engine and check operation in forward, re-
verse and neutral. Readjust if needed for correct op-
eration.
3. On vehicles without a shift lever neutral position (Fig.
8):
A. Move shift lever to forward.
B. Extended spring length on shift cable should be 1
to 1 1/8" (25 to 25 mm). Adjust lock nut as needed.
C. Move shift lever to reverse. Check other shift
cable as in Step 3. Adjust lock nut as needed.
D. Start engine and check operation in forward and
reverse. Readjust if needed for correct operation.
Drive Train
1. Shift cable
2. Select lever assembly
2
4
3
1. Select lever
2. Cable pull direction
3. Cable boot
1. Select lever assembly
Page 5 - - 6 Rev. A
1
3
2
Figure 6
3. Locknut
2
5
1
Figure 7
4. Incorrect adjustment
5. Correct adjustment
1 to 1 1/8"
2
(25 to 28 mm)
2
1
Figure 8
2. Shift cable
Workman 1100/2100/2110
3