Toro Workman 1100 Service Manual page 51

5. Remove four long cap screws securing the shift plate
to the seat base (Fig. 15). Separate shift bracket from
the choke cable and seat base.
6. Remove four hex head flange screws and flat wash-
ers securing the front of the seat base to the frame. Re-
move four hex head flange screws securing the back of
the seat base to the frame.
IMPORTANT:Make sure shift bracket, shift cables,
choke cable, and fuel tank do not catch on the seat
base during removal.
7. Lift seat base carefully from the machine.
Seat Base Installation (Fig. 14)
IMPORTANT:Make sure shift bracket, shift cables,
choke cable, and fuel tank do not catch on the seat
base during installation.
1. Position seat base carefully to the frame.
Note: Do not tighten fasteners securing the seat base
to the frame until all of them are installed.
2. Install four hex head flange screws and flat washers
through the frame and to the front of the seat base.
Install four hex head flange screws through the frame
and into the back of the seat base. Tighten all fasteners.
3. Place shift bracket, shift cables, and choke cable
through the opening at the front of the seat base.
4. Position choke cable and shift plate to shift bracket
making sure to capture cable flange. Secure shift plate
to shift bracket with four short cap screws. Screw knob
onto the shift lever (Fig. 15).
5. Position shift plate with shift bracket to the seat base.
Secure shift plate to seat base with 4 long cap screws
(Fig. 15).
6. On Workman 1110 machines, install parking brake
assembly to seat base (see Parking Brake Assembly in
the Service and Repairs section of Chapter 7 – Chassis,
Wheels, and Brakes).
Fuel Tank Removal (Fig. 16)
WARNING
Use caution when working with fuel system com-
ponents (see Fill Fuel Tank and Fuel Safety Pre-
cautions).
1. Remove seat base from the frame (see Seat Base
Removal).
Workman 1100/1110
2. Loosen hose clamp and disconnect fuel hose from
the tank.
3. Release tank strap from fuel tank. Do not remove
strap from floor plate and frame cross member. Remove
tank from frame.
Fuel Tank Installation (Fig. 16)
1. Position fuel tank to frame. Secure tank to frame and
cross member with tank strap.
2. Connect fuel hose to the tank and secure with hose
clamp.
3. Install seat base to the frame (see Seat Base Instal-
lation).
2
3
1. Shift lever
2. Cap screw (short)
3. Shift plate
1
3
1. Fuel hose
2. Fuel tank
Page 4 – 13 Rev. B
4
5
1
Figure 15
4. Cap screw (long)
5. Choke cable
Figure 16
3. Tank strap
Kohler Gasoline Engine
2