Adjustments; Adjust Starter/Generator Belt; Adjust Throttle Cable - Toro Workman 1100 Service Manual

Adjustments

Adjust Starter/Generator Belt

Note: Perform this maintenance procedure at the in-
terval specified in the Operator's Manual or Chapter 2
– Product Records and Maintenance.
1. Park machine on a level surface, stop engine, en-
gage parking brake, and remove key from the ignition
switch.
2. Lift cargo bed and prop with rod to gain access to the
engine.
3. Loosen starter/generator pivot bolt.
4. Wedge a pry bar between the engine mount and
starter. Loosen the nut on the adjusting carriage bolt.
5. Pivot the starter in the slot until the belt flexes 1/4 inch
(6 mm), with 10 lb (4.5 Kg) of force.
6. Tighten the carriage bolt nut. Tighten starter genera-
tor pivot bolt.

Adjust Throttle Cable

Releasing the accelerator pedal should allow the throttle
cable to close the carburetor throttle control lever so that
the lever touches the adjustment screw. The adjustment
screw keeps the throttle valve inside the carburetor
open slightly to prevent the valve from binding.
1. Park machine on a level surface, stop engine, en-
gage parking brake, and remove key from the ignition
switch.
2. Lift cargo bed and prop with rod to gain access to the
engine.
3. Rotate governor arm fully clockwise (Fig. 5).
4. Make sure of the following:
A. The throttle control lever should be to the fully
open position.
B. Adjust throttle cable at the cable bracket as nec-
essary, so there is no compression of the throttle
cable (Fig. 5). This will allow the throttle control lever
to fully close when the accelerator pedal is released.
Kohler Gasoline Engine
1. Starter/Gen. pivot bolt
1. Governor arm
2. Throttle cable
Page 4 – 6
2
1/4"
10 lb
Figure 4
2. Carriage bolt
2
3
Figure 5
3. Cable bracket
Workman 1100/1110
1
1