Toro Workman 1100 Service Manual page 85

7. Disassemble governor fork and shaft.
1. Screw
2. Stopper
IMPORTANT: Make sure not to damage the screw
heads when removing screws. Each screw is se-
cured with an adhesive.
1. Governor shaft
2. Boss
IMPORTANT: Make sure not to damage the oil seal
when removing the governor shaft from the gover-
nor boss.
Workman 1100/2100/2110
4
1
Figure 48
3. Governor fork
4. Case (RH)
3
Figure 49
3. Oil seal
Page 5 – 31
3
2
A. Remove both screws and washers securing the
stopper and governor fork to the case (RH). Remove
stopper and fork from the case.
1
2
B. Pull governor shaft from the boss.
C. Replace oil seal if if cracked, nicked, or distorted
such that it would not hold a proper seal.
Drive Train