Toro Workman 1100 Service Manual page 76

1. Case (RH)
IMPORTANT: Make sure not to hit the governor
boss too hard when separating the cases, the boss
may get damaged. Do not pry open the two cases
with a screw driver, damage may result to the seal-
ing surfaces.
2. Remove input shaft, center shaft, and differential assemblies.
1. Gasket
A. Remove gasket and pipe knocks.
Drive Train
1
Figure 32
2. Governor boss
G. Hold the case (RH) and lift up while lightly tapping
the governor boss with a plastic hammer.
Figure 33
2. Pipe knock
Page 5 – 22
2
2
1
Workman 1100/2100/2110