Transaxle; Removal - Toro Workman 1100 Service Manual

Transaxle

Removal

1. Park machine on a level surface, stop engine, set
parking brake, and remove key from the ignition switch.
2. Remove cargo box from the frame (see Cargo Box
Removal in Chapter 7 – Chassis, Wheels, and Brakes).
3. Remove drive belt from the driven clutch (see Ser-
vice Drive Belt in Engine Chapter).
4. Remove tie wraps securing both battery cables to
the passenger side axle tube.
5. Remove governor and cable brackets from the trans-
axle as follows (Fig. 21).
A. Scribe mark across governor bracket and gover-
nor shaft to help reinstallation. Loosen both set
screws securing the bracket to the shaft.
B. Remove both lock nuts securing the cable brack-
et to the transaxle case. Remove both brackets and
cables as a complete unit from the transaxle case
and governor shaft.
6. Remove lock nut securing the select lever assembly
to the selector shaft. Loosen jam nuts securing both shift
cables to the cable bracket. Separate select lever as-
sembly and shift cables from the transaxle (Fig. 22).
WARNING
Before jacking up the machine, review and follow
Jacking Instructions in Chapter 1 – Safety.
7. Jack up both sides of the frame (at the jacking point
indicated) enough to remove rear wheels (Fig. 23).
A. Chock the front and rear of both front tires to pre-
vent the vehicle from moving.
B. Support both sides of the frame with jackstands
positioned just in front of the axle tubes. This will al-
low the transaxle to be removed from the rear of the
vehicle.
8. Remove both wheels and brake assemblies from the
transaxle (see Rear Wheel and Brake Removal in Chap-
ter 7 – Chassis, Wheels, and Brakes).
9. Attach hoist or chain fall to the engine mount to lower
the engine and transaxle. Make sure lifting device is at-
tached to hold the full weight of the engine and mount.
Drive Train
4
1. Scribe mark
2. Governor bracket
3. Set screw
1. Select lever assembly
2. Shift cable
4
5
3
2
1
1. Flange lock nut
2. Flat washer
3. Isolation mount
4. Cap screw
Page 5 – 16
5
3
2
Figure 21
4. Lock nuts
5. Cable bracket
2
2
1
3
Figure 22
3. Lock nut
4. Cable bracket
8
JACKING POINT
Figure 23
5. Rear frame
6. Flange lock nut
7. Hex head flange screw
8. Transaxle
Workman 1100/2100/2110
1
4
6
7