Electrical System Quick Checks; Battery Test - Toro Workman 1100 Service Manual

Electrical System Quick Checks

Battery Test

Use a multimeter to measure the voltage between the
battery terminals.
Set the multimeter to the DC volts setting. The battery
should be at a temperature of 60
key should be off and all accessories turned off. Connect
the positive (+) meter lead to the positive battery post
and the negative (–) meter lead the the negative battery
post.
NOTE: This test provides a relative condition of the bat-
tery. Load testing of the battery will provide additional
and more accurate information.
Electrical System
to 100 F. The ignition
o o
Page 6 – 6
Voltage Measured
12.68 V (or higher)
12.45 V
12.24 V
12.06 V
11.89 V
Workman 1100/1110/2100/2110
Battery Charge Level
Fully charged (100%)
75% charged
50% charged
25% charged
0% charged