Getting Started With The Usb Base Station; Powering On The Handset; Figure 3-3: Connect To The Line Port - Linksys CIT300 User Manual

Getting Started with the USB Base Station

To connect the USB base station, follow these instructions:
1. If you have a landline, connect a RJ-11 telephone cable (included) to the LINE port of the USB base station.
Then connect the other end to your telephone wall jack.
2. Connect the USB cable of the USB base station to a USB port on your Skype-enabled PC.
3. Connect the included power adapter to the power port of the USB base station. Then plug the power adapter
into an electrical outlet.
Proceed to the next section, "Powering On the Handset."

Powering On the Handset

When the handset is fully charged, press and hold down the Power or End Call key for two seconds; this will
power on the handset. To power off the handset, press and hold down the Power or End Call key for
two seconds.
Proceed to the next section, "Setting Up Your PC."
Chapter 3: Getting Started
Getting Started with the USB Base Station
Dual-Mode Internet Telephony Kit
Figure 3-3: Connect to the
LINE Port
15