Sequence Match Beeper; Partial Sequence; Require Output Sequence - Honeywell Stratos 2700 User Manual

cover of this manual, then scanning Save. Default = 5000 msec.

Sequence Match Beeper

By default, the scanner beeps when a sequence match is found. If you want the scanner to remain silent, scan the follow-
ing Sequence Match Beeper Off bar code. Default = Sequence Match Beeper On.
Sequence Match Beeper Off

Partial Sequence

If an output sequence operation is terminated before all your output sequence criteria are met, the bar code data acquired
to that point is a "partial sequence."
Scan Discard Partial Sequence to discard partial sequences when the output sequence operation is terminated before
completion. Scan Transmit Partial Sequence to transmit partial sequences. (Any fields in the sequence where no data
match occurred will be skipped in the output.)
is reached, the partial sequence is transmitted. Default = Discard Partial Sequence.
Transmit Partial Sequence

Require Output Sequence

When an output sequence is Required, all output data must conform to an edited sequence or the scanner will not transmit
the output data to the host device. When it's On/Not Required, the scanner will attempt to get the output data to conform
to an edited sequence but, if it cannot, the scanner transmits all output data to the host device as is.
Sequence Timeout
If you have programmed a
* Sequence Match Beeper On
Sequence Timeout (page 4-18) and the timeout
* Discard Partial Sequence
4 - 19