Honeywell Stratos 2700 User Manual page 154

If you scan the Require User-Defined Sequence code, the data combination specified in the User-Defined concatenation
sequence is required to transmit the data. No data is output unless the sequence is read.
Default = Off.
* Off
Require User-Defined Sequence
Content Verification
When the On bar code is scanned, the check character values are output along with the bar code data, thus allowing you to
verify that the check character is in agreement with that calculated for the data stream. Default = Off.
On
Transmit Identifiers
You may disable the transmission of the ISBT Code 128 data identifiers by scanning Off. When this selection is Off, the
first 2 data (ID) characters are removed from the data stream unless the ISBT code contains the Donation Identification
Number identifiers. If the code contains the Donation Identification Number identifiers, only the first ID character is
removed from the Donation Identification Number. The second character is transmitted as normal data. Default = On.
* On
9 - 24
Allow User-Defined Sequence
* Off