Push Button Functionality - Honeywell Stratos 2700 User Manual

LEDs (Continued)
Green, Red, Yellow Flash
Green, Red, Yellow Flash
Red Flash
Red Flash, then Continuous
Green Flash
Green Flash

Push Button Functionality

There is a ring of 4 push buttons on the front of the device. The following is a brief description of the default settings for the push
buttons. For complete functionality and programming options, refer to
Note: Pressing the Sound button wakes the scanner from sleep mode.
Scale Zero
This button is normally lit when the scale is at zero. The backlight goes off when the scale is not at zero. Press this button
to reset the scale to zero.
Image Capture
Press this button once to scan a bar code using a customer-facing scanner (if installed). Push it a second time to disable
the customer-facing scanner. See
Sound
Press repeatedly to scroll through the beeper volumes. This button is also used to clear error conditions (LED lights,
beeps, and LCD notifications). Hold this button down for 5 seconds to put the scanner to sleep.
1 - 4
Sound
Auxiliary Scanner Beep
With or without Beep
Razz
Razz
Cuckoo Beep
Ascending 3 Tone
Image Capture Button on page 4-7 for further information.
Indication
Auxiliary Scanner Configuration
Scale Calibration
Error Event - Minor (See
Stratos Bioptic Scanner,
15-1)
Error Event - Major (See
Stratos Bioptic Scanner,
15-1)
Configuration Code - Temporary
Configuration Code - Permanent
Push Buttons
Button Controls on page 4-4.
Troubleshooting a
beginning on page
Troubleshooting a
beginning on page