Block Check Character; Ncr Prefix; Ncr Suffix; Ncr Nof (Not-On-File) Error - Honeywell Stratos 2700 User Manual

Block Check Character

When this selection is set to Transmit, the NCR Block Check Character (BCC) is expected with incoming messages and
transmitted with outgoing messages. Default = Transmit.
* Transmit

NCR Prefix

This selection allows you to program an NCR-specific prefix. Refer to the
page A-3 to find the hex equivalent for the characters you want for the NCR prefix (typically, 02 for STX). Scan the bar code
below, then set the hex number (from 0-FF) by scanning digits from the
Default = 0.

NCR Suffix

This selection allows you to program an NCR-specific suffix. Refer to the
page A-3 to find the hex equivalent for the characters you want for the NCR suffix (typically, 03 for ETX). Scan the bar code
below, then set the hex number (from 0-FF) by scanning digits from the
Default = 0.

NCR NOF (Not-on-File) Error

A scanner receives an NOF (Not on File) command from the POS whenever it cannot cross-reference the bar code to a
price parameter. When set to On, the error tone sounds for an NOF, and disables the scanner while the cashier looks up
the price manually. (The tone is set via
on-File) Number of Beeps, page 3-35). When set to Off, a good read beep sound is emitted for an NOF. Default = Off.
On
3 - 34
NCR Prefix
NCR Suffix
Beeper Pitch – Error, page 4-11 and number of beeps are set via
ASCII Conversion Chart (Code Page 1252)
Programming Chart, then scanning Save.
ASCII Conversion Chart (Code Page 1252)
Programming Chart, then scanning Save.
Don't Transmit
on
on
NCR NOF (Not-