Honeywell Stratos 2700 User Manual page 182

EAN/JAN-8 Redundancy
If you are encountering errors when reading EAN/JAN-8 bar codes, you may want to adjust the redundancy count. Redun-
dancy adjusts the number of times a bar code is decoded before transmission, which may reduce the number of errors.
Note that the higher the redundancy count, the longer it will take to decode the bar code. To adjust the redundancy, scan
the EAN/JAN-8 Redundancy bar code below, then scan a redundancy count between 0 and 10 on the Programming Chart
inside the back cover of this manual. Then scan the Save bar code. Default = 0.
EAN/JAN-8 Redundancy
UPC/EAN Addenda Redundancy
This programs the number of redundant scans required of a 2 or 5-digit addendum before it is attached to the UPC or EAN
bar code and submitted. To adjust the redundancy, scan the Redundancy bar code below for the 2 or 5-digit addenda you
want to adjust, then scan a redundancy count between 0 and 10 on the Programming Chart inside the back cover of this
manual. Then scan the Save bar code. Default = 2 for 2-Digit Addenda, 1 for 5-Digit Addenda.
2-Digit Addenda
Redundancy
5-Digit Addenda
Redundancy
9 - 52