RS232 Defaults
If you want the custom RS232 default settings restored to your scanner, scan the RS232 Defaults bar code below. This
resets the scanner to the custom default settings (see
defaults, it will reset the scanner to the factory default settings. Any settings that have not been specified through the cus-
tom defaults will be restored to the factory default settings.
NCR Modifiers
NCR ACK/NAK
This is an NCR communication protocol for ACK/NAK processing. Default = NCR ACK/NAK Off.
* NCR ACK/NAK Off
NCR Modes
Scan one of the following bar codes to set the message mode for an attached NCR device.
NCR Scanner Only Mode
Scan the NCR Scanner Only Mode On bar code to select the NCR scanner-only message format. (For more informa-
tion, refer to the NCR Scanner/Scale Programmer's Guide.) Default = NCR Scanner Only Mode Off.
* NCR Scanner Only Mode Off
3 - 32
Setting Custom Defaults
RS232 Defaults
on page 3-1). If there are no custom
NCR ACK/NAK On
NCR Scanner Only Mode On